Hi started using multiplicity pro seamless connections and i have problem with cursor position while transitioning between certain screens.

I get the same behavior but from different monitor depending if i have the advanced resolution aware grid mode on or not.

My setup has 4 screens.  2  on top of each other on the main machine using extended desktop.  and 2 seamless connection machines on the left  stack of top of each other. Pic linked of the config.

https://ibb.co/tTxJCpXL

With advanced resolution aware grid mode OFF    i can move the mouse freely between  the 2 left monitor up and down with no problem.  but this mode does not see my extended desktop monitor on the main machine so transitioning from the top monitor to the top left monitor is actually moving the cursor to the bottom monitor not the top one.

Now if i enable the advanced resolution aware grid mode.

https://ibb.co/pBKRcx7v

The extended desktop monitor on the main computer is detected.  Now i can transition properly between the 2 top monitors with no problem. 

The major problem now is transitioning between the 2 left monitors, up or down.  it lag and the cursor get pushed to right of other the monitor.  Example if my cursor is on the top left monitor  if i want to move to the bottom left monitor  from the bottom right corner the cursor will end up in the top left corner of the bottom monitor. This same operation was work perfectly when advanced resolution aware grid mode is off but i need to turn it on to be able to detect my extended desktop monitor.

All monitor have the same resolutions 1920x1080  with 100% scaling all landscape.

on multiplicity pro  not using advanced resolution aware grid mode should also detect the extended desktop monitor like aware grid does.